by tatoosh » Sat Jan 24 2015 16:45
by victor » Wed Mar 11 2015 09:39
No valid /etc/lirc/lircd.conf has been found..
Remote control support has been disabled..
Reconfigure LIRC or manually replace /etc/lirc/lircd.conf to enable..
irrecord -n -d /dev/lirc0 ~/lircd.conf
by MZP » Mon Aug 01 2016 16:18
by kaptainen » Fri Oct 07 2016 12:48
by marcos » Mon Mar 06 2017 11:56
by tiroy_ » Thu May 23 2019 17:49
by ashthespy » Thu May 23 2019 18:34
tiroy_ wrote:HI all
Is it possible to use with Tsop4838 IR receiver on top of pHAT DAC? This DAC uses all I2S pins https://pinout.xyz/pinout/phat_dac
If yes, then is there any additional configuration required?
by tiroy_ » Thu May 23 2019 19:40
ashthespy wrote:I2C != I2S
by ashthespy » Thu May 23 2019 22:26
tiroy_ wrote:ashthespy wrote:I2C != I2S
It may be true, but how does this answer my question?
by tiroy_ » Fri May 24 2019 17:14
ashthespy wrote:tiroy_ wrote:ashthespy wrote:I2C != I2S
Either way, IR works with most GPIOs, as it's just a pulse stream that is read. So it's just a matter of telling lirc which GPIO you are using by setting the corresponding dt overlay parameters:
- Code: Select all