DAC connections - PCM5102

Diy? Low-budget? Esoterics? Let's discuss about DACS!

Ads helps Volumio remain Free and Open Source. Please consider donating to help us continue to serve you.

DAC connections - PCM5102

Postby ashthespy » Wed Nov 16 2016 14:40

I just picked up a really cheap PCM5102 based board to see if my pi0 was capable to being my music streamer.
The board in question is:
Image
Old connections:
Connections:
Vcc - pi 5v pin 2
3.3v - pi 3.3v pin 1
GND - pi gnd pin 39
FLT -
DMP -
SCL - pi SCL pin 5
BCK - pi BCK pin 12
DIN - pi Data pin 40
LCK - pi LCK pin 35
FMT -
XMT -

Software: Volumio 2.001 & output device as Hifiberry Dac

However, no music :-(
Anyone have any experience with this board? I am now going to try pulling the FMT and FLT to low as the datasheet recommends.

EDIT: Looked up the data sheet and now it works fine :-)
Here is the correct pinout:
Vcc -
3.3v - pi 3.3v pin 1
GND - pi gnd pin 39
FLT - pi gnd
DMP - pi gnd
SCL - pi SCL pin 5
BCK - pi BCK pin 12
DIN - pi Data pin 40
LCK - pi LCK pin 35
FMT - pi gnd
XMT - pi 3.3v
User avatar
ashthespy
Objectivist
Objectivist
 
Posts: 280
Joined: Fri Jul 22 2016 08:16

Ads helps Volumio remain Free and Open Source. Please consider donating to help us continue to serve you.


DAC connections - PCM5102

Postby zomtec » Thu Jul 06 2017 18:09

I have the same and it work. I can controll the volume over the web page volumio.local. But not with MPD.

Can you controll volume with MPD?
User avatar
zomtec
Fresh off the boat
Fresh off the boat
 
Posts: 3
Joined: Wed Jul 05 2017 17:04


Return to DACs

Who is online

Users browsing this forum: No registered users and 0 guests